All Activity

No, but anyone with common sense knows that there won't be 2 snow events post-March 10. That's only happened once ever (in 2018), and temperatures had cooled long before that. We won't get 2 snow events after this warmup. Besides, I haven't been wrong on everything this winter. I did say December would be below average temperaturewise, and I called this March warmup at least a month in advance.

I just hope my drive to work isn't like this morning.. Rt 2 was a disaster traffic stopped at one point driving in..

It looks to be a very narrow area should that happen.

I do but wait and see.. someone will get nailed.. been mentioning this for 5 days or so now

I think so. Best chance for snow and sleet is rt 2 north but we’ll see.

AEMATT stealing my QPF again kidding aside there’s some interesting runs from Ray to Scoot.

Further south cold rain, huh…

Sleet and snow AWT. Don’t think ZR a big issue right now.

About 4" here in Brattleboro. It stayed all snow until around 9pm. I was expecting only a couple inches, so this was an overperformer!

Hopefully the heaviest precip ends up over SNE tomorrow night.. let's juice this up

Rt2 is a disaster.. saw 3 accidents in leominster and cops looked like they were heading to.another one as I was getting off my exit..super icy

Man all glazed up. Thought I would rot at 32.5. Looks like it was 32.0 for hours. Now cleared and temp dropping.

Could be interesting here tomorrow night.

Congrats Dendrite

5.3” A little more than I was expecting. Shoveled steps and around the cars but will let the sun vaporize the rest

You might be too by mid month…

Same here. Light is what you want if you want it to accrete efficiently, and not run off.

Maine is so lucky

Are you related to snowman19? You have been wrong on everything this winter.

BDL/Windsor Locks way better than up there most times.

31F with freezing rain.

Good enough for CoastalWx standards? Reliable report of 5.9" In FIT (not in PNS yet). That is very respectful for such a "minor" event. And now widespread 1/4" glaze in parts of SNE. This seals the pack so it is "protected" a bit longer!

It's just over the line, I agree. Leaving it to melt ia not quite an option just yet, especially if the areas you need to clear are shaded or north-facing.